Label I Feed Good L, Technical Manual

Page: 87 / 132

i • FeedGood
L
• Technical Guide | 85
Calibration by Load Cells Parameters
This is to calibrate the scale when it is connected to the load cells
not listed in Table 1.
1. To execute the Calibration, select the item “CAL. by
PARAMETERS”, then press
u .
The display shows the message “Do you want to execute the
Calibration?”.
2. Press OK to confirm.
The display shows the message “Set the parameters and
press OK.” and after 3 seconds the previously set
parameters.
3. Set the number of load cells, then press OK .
4. Set the capacity of the load cells, then press OK .
5. Set the sensitivity of the load cells, then press OK .
6. Press OK to confirm the Calibration.
The display shows the message "Calibration in progress.
Wait...” and at the end the message “Calibration executed
correctly.”.