KYMCO Downtown 300i ABS, Service Manual

Page: 8 / 263

1. GENERAL INFORMATION
1-5
Downtown 300i ABS

Do not squeeze wires against the weld or
its clamp.

After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.

When fixing the wire harnesses, do not
make it contact the parts that will generate
high heat.

Route wire harnesses to avoid sharp
edges or corners. Avoid the projected
ends of bolts and screws.

Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.

Route harnesses so they are neither pulled
tight nor have excessive slack.

Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge
or corner.

When rubber protector cover is used to
protect the wire harnesses, it shall be
installed securely.

Do not break the sheath of wire.

If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.

When installing other parts, do not press
or squeeze the wires.

After routing, check that the wire
harnesses are not twisted or kinked.
Do not pull
too tight
！
No Contact
Do not press or
squeeze the wire