Erreur ! Style non défini.
Erreur ! Style non défini.
22
5.7 Fitting the pto shaft
Only pto shafts supplied or recommended by the manufacturer should be used.
When first attaching the spreader to the tractor, the length of the shaft must be
matched to the tractor.
Read the pto manufacturer's operator manual care-
fully, taking special note of the instructions concerning the shortening of
the shaft.
This operator manual is found attached to the pto shaft. If the shaft
is too long, both pto drive and spreader may be damaged when the unit is rai-
sed.
Fitting and removing the pto shaft
Injury or death hazard due to rotating shaft
•
Before fitting or removing the pto shaft, make sure that the pto drive is di-
sengaged, the tractor engine switched off and the ignition key removed.
Always fit the shaft the correct way round. The end marked with a tractor sym-
bol must be fitted on the tractor side.
1.
Unscrew the locking screw
2.
Turn the guard muff into its unlocked
position
3.
Pull the shaft out
4.
Remove the guard muff and grease
the pto spline shaft. Place the pto
shaft in position and tighten the bolt
DANGER
