KFU 2-/4-
94
SETUP Selection
796
Function
33 -
Calc. and para ident.,
DS3
Further motor data are measured, dependent pa-
rameters are calculated and the parameter values
are saved in data set 3.
34 -
Calc. and para ident.,
DS4
Further motor data are measured, dependent pa-
rameters are calculated and the parameter values
are saved in data set 4.
110 -
Complete Setup w/o
Para-Ident., DS0
The auto set-up routine is performed in data set 0
and the parameter values are stored in all of the
four data sets identically. Extended motor data are
not measured.
111 -
Complete Setup w/o
Para-Ident., DS1
The parameter values of the auto set-up are stored
in data set 1. Extended motor data are not meas-
ured.
112 -
Complete Setup w/o
Para-Ident., DS2
The parameter values of the auto set-up are stored
in data set 2. Extended motor data are not meas-
ured.
113 -
Complete Setup w/o
Para-Ident., DS3
The parameter values of the auto set-up are stored
in data set 3. Extended motor data are not meas-
ured.
114 -
Complete Setup w/o
Para-Ident., DS4
The parameter values of the auto set-up are stored
in data set 4. Extended motor data are not meas-
ured.
The individual steps of the auto set-up routine can be monitored and checked via
parameter
SETUP Status
797
. The setup routine via the communication interface
continuously updates the status parameter which can be read out via the interface.
Status messages
Message
Meaning
OK
Auto set-up routine has been carried out.
PC Phase 1
The plausibility check of the motor data is active.
PC Phase 2
The calculation of dependent parameters is active.
STO
The parameter identification demands the controller release
on digital input S1IND/STOA and S7IND/STOB.
Parameter identifica-
tion
The rated motor values are checked by the parameter iden-
tification feature.
Setup already active
The setup routine via the control unit is being carried out.
No
enabling
signal
The parameter identification demands the controller release
on digital input S1IND/STOA and S7IND/STOB.
Error
Error during the auto set-up routine.
Warning phase asym-
metry
The parameter identification feature diagnosed an unbal-
ance during the measurements in the three motor phases.
