Kubota RTV1140CPX, Workshop Manual

Page: 175 / 379

TRANSMISSION
RTV1140CPX, WSM
2-S12
Checking Travelling Speed
CAUTION
• Park the machine on a hard and level surface.
• If it is necessary to run engine in an enclosed area, use a
gas tight exhaust pipe extension to remove the fumes.
• Always try to work in a well-ventilated area.
• Lift up and secure with jack stands or blocking the front of
machine, do not run the machine while adjusting.
• Work by two people when you checking and adjusting
travelling speed.
1. Set the 4WD lever to 2WD position.
2. Start the engine and shift the range shift lever in
L position and
depress the differential lock pedal.
3. Depress the speed control pedal (2), and measure the rotations
of rear wheel. (Engine speed is set with tachometer.)
4. If the measurement is not within the factory specification, loosen
the lock nut and adjust the length of the speed control pedal
stopper bolt (1).
NOTE
• Confirm the position of the HST control becomes the
foremost position when fully depress the speed control
pedal, and the HST control rod is not pulled too much.
• And confirm whether to pull the accelerator wire too much
at same time.
• Refer to the following paragraph a detailed adjustment of
above-mentioned two points.
9Y1210293TRS0009US0
Rear wheel rotation
(axle) at
L speed
Factory specification
106 to 119 min
-1
(rpm) at
rated engine speed
(3000 min
-1
(rpm))
(1) Speed Control Pedal Stopper Bolt (2) Speed Control Pedal
KiSC issued 05, 2014 A