Kubota RTV1140CPX, Workshop Manual

Page: 266 / 379

FRONT AXLE
RTV1140CPX, WSM
5-S8
(Continued)
(When reassembling)
• When installing the strut (1) to knuckle case, set the wedge to
decide the position of strut to the slit of the knuckle case.
• When inserting the cotter pin, if the slots in the nut do not align
with the cotter pin hole in the tie-rod end and case mounting
bolt, tighten the nut clockwise up to next alignment.
• If should be within 30 degree.
• Loosen once and tighten again when the slit goes past the
nearest hole.
• After tightening the these slotted nut to specified torques, install
a cotter pin as shown figure left.
NOTE
• Tighten the lower arm mounting bolt and nut (3) with the
specified torque after setting up the wheel and unloading
the machine on ground.
• Tighten the slotted nut to 150 N·m (15.3 kgf·m, 110 lbf·ft). If
the slot and pin hole do not meet, tighten the nut until they
do meet, and install cotter pin.
• Be sure to split the cotter pin like an anchor.
9Y1210293FAS0009US0
Tightening torque
Tie-rod end slotted nut
50 N·m
5.1 kgf·m
37 lbf·ft
Ball joint mounting screw
and nut
48.0 to 55.9 N·m
4.90 to 5.70 kgf·m
35.4 to 41.2 lbf·ft
Front axle slotted nut
150 N·m
15.3 kgf·m
111 lbf·ft
Knuckle case mounting bolt
and slotted nut
50 N·m
5.1 kgf·m
37 lbf·ft
Strut mounting nut
48.0 to 55.9 N·m
4.90 to 5.70 kgf·m
35.4 to 41.2 lbf·ft
Lower arm mounting bolt
and nut
103 to 117 N·m
10.5 to 12.0 kgf·m
763.0 to 86.7 lbf·ft
(1) Strut
(3) Lower Arm Mounting Bolt and Nut (13) Slit
KiSC issued 05, 2014 A