Kubota RTV1140CPX, Workshop Manual

Page: 221 / 379

REAR AXLE
RTV1140CPX, WSM
3-S3
3. CHECKING, DISASSEMBLING AND SERVICING
[1] CHECKING
Checking Shock Absorber
1. Visually check the shock absorber (1) for breaks or distortion.
2. If the shock absorber is damaged in any way, replace it.
3. Check for oil leakage at the shock absorber.
4. If oil leakage is noted, replace it.
5. Push, and shorten the shock absorber, and check whether to
return in former state.
6. Replace the shock absorber for the new one if it does not return
to former state.
7. Visually check the rubber bush in the upper and lower
mountings of the rear shock absorber.
8. If they are worn, cracked, hardened, or otherwise damaged,
replace them with new one.
9Y1210293RAS0003US0
[2] PREPARATION
(1) Rear Axle Bracket Assembly
Cargo Bed
1. Lift up the cargo bed (1) by hand and support it with the safety
support so that the hydraulic cylinder should not drop.
2. Remove the cotter pin and clevis pin (2).
3. Disconnect the connector (3) from main harness, then separate
the harness for the tail lamps.
4. Loosen the lock nut (4) and remove the hinge bolt (5) and nut.
9Y1210293ENS0001US0
(1) Shock Absorber
(1) Cargo Bed
(2) Clevis Pin
(3) Connector (4) Lock Nut
(5) Hinge Bolt
KiSC issued 05, 2014 A