Kubota RTV1140CPX, Workshop Manual

Page: 356 / 379

ELECTRICAL SYSTEM
RTV1140CPX, WSM
8-S13
(5) Safety Switch
Safety Switch Continuity
1. Remove the safety switch leads.
2. Connect the circuit tester to the safety switch leads.
3. Measure the resistance between leads.
4. If the safety switch is defective, replace it.
9Y1210293ELS0015US0
(6) Engine Stop Solenoid
Engine Stop Solenoid
1. Disconnect the 2P connector (1) from the engine stop solenoid
(2).
2. Remove the engine stop solenoid (2) from the engine.
3. Connect the jumper leads from the pulling coil
P terminal to the
switch (5), and from switch (5) to the battery positive terminal.
4. Connect the jumper leads from the holding coil H terminal to the
switch (6), and from switch (6) to the battery positive terminal.
5. Connect the jumper leads from the engine stop solenoid body to
the battery negative terminal.
6. When switch (6) is turn on, the plunger pulls into the solenoid
body and then turn off the switch (6), the plunger comes out.
7. Turn on the switch (5) then turn on the switch (6), the plunger
pulls into the solenoid body and it keeps in holding position after
turning off the switch (6).
8. If the plunger is not attracted, the engine stop solenoid is faulty.
IMPORTANT
• Never apply the current for pulling coil more than two
seconds when inspecting.
9Y1210293ELS0016US0
Resistance (Across
switch terminal)
When you move the
gear shift lever
Infinity
When you return the
gear shift lever
0 Ω
(1) Safety Switch for Main Shift Lever
(1) 2P Connector
(2) Engine Stop Solenoid
(3) Connector (of Engine Stop
Solenoid)
(4) Battery
(5) Switch for Holding Coil
(6) Switch for Pulling Coil
P: Terminal for Pulling Coil
H: Terminal for Holding Coil
KiSC issued 05, 2014 A