Kongsberg Simrad CS90, Reference Manual

Page: 336 / 686

334
442700/A
Bearing
The bearing for the Vertical view is controlled by the bearing in the Horizontal view.
You can change the bearing on the
Main
menu. You can also select the bearing line in
a Horizontal view and drag it sideways.
Tip
The
Bearing
function controls the horizontal direction of the Vertical view and the
inspection beam.
If you use a presentation mode with two vertical views you can set the
Bearing
function to two different values. Both bearing lines are shown in the Horizontal view.
The bearing for the Vertical view is shown with a solid line. The bearing for the
Vertical 2 view is shown with a dotted line.
Tilt
The current tilt is shown with a solid line. You can change the tilt angle by means of
the
Tilt
function on the
Main
menu. You can also click on the tilt line and drag it up
and down. When you change the tilt a dotted line presents the requested tilt while the
solid line presents the actual tilt.
If you use a presentation mode with two vertical views you can use two different tilt
values. The tilt in the
Vertical view is shown with a solid line. The tilt in the Vertical 2
view is shown with a dotted line.
Depth
/
Range
/
Range Rings
Horizontal dotted lines show the depth intervals. Use
Depth Dividers
on the
Cosmetics
menu to toggle these lines On or Off .
Range rings are a set of concentric circles labelled by distance from the vessel
position. The selected range is divided into identical distances. The range rings are
shown as dotted lines. Each ring has a range read-out. Use the
Range Rings
function to
toggle the range rings On or Off .
Simrad CS90 Reference Manual