Kongsberg Simrad CS90, Reference Manual

Page: 426 / 686

424
442700/A
Note
The choice you make is by default only applied to the currently selected (active) view. The
active view is identified with a thicker border.
A new manually initiated tracked object is automatically given priority status. The priority
is identified with a "P". The bearing and tilt settings are automatically adjusted to follow the
movements of the tracked target. The bearing line is automatically locked on the object to
reflects its bearing.
Details
Bearing
The following methods can be used to adjust this setting:
• In a Horizontal view, select the bearing line and drag it sideways.
• Use the Operating Panel.
• Select either side of the button to choose a value.
• Select the middle of the button to open it. If you have a keyboard connected to the
CS90 system, type the requested value.
Auto
This is an "on/off" function. Set this function
to
On to start the automatic search function.
In the Auto Bearing mode the CS90 system
will automatically search within defined sector
limits. The sector is identified in the view
using two angular symbols.
Illustration:
A
Search sector
B
Bearing line
Select
Step
to set the size (in degrees) of each
bearing step.
Select
Sector
to set the size (in degrees) of the
horizontal search sector.
Tip
This function can be assigned to the F1, F2
or F3 button on the Mk2 Operating Panel.
Simrad CS90 Reference Manual