8.9
Section 8
Disassembly
8
Figure 8-34. Removing Wiring Harness.
Remove Backing Shroud Assembly
1. Remove the four mounting screws securing the
backing shroud assembly to the crankcase. See
Figure 8-35.
Figure 8-36. Removing Spark Plugs.
Remove Valve Covers and Fuel Pump
WARNING: Explosive Fuel!
Gasoline is extremely flammable and its vapors can explode if
ignited. Store gasoline only in approved containers, in well
ventilated, unoccupied buildings, away from sparks or flames.
Do not fill the fuel tank while the engine is hot or running,
since spilled fuel could ignite if it comes in contact with hot
parts or sparks from ignition. Do not start the engine near
spilled fuel. Never use gasoline as a cleaning agent.
NOTE
: Based on the style of fuel pump used refer to
the following when removing valve covers.
Mechanical Fuel Pump
1. The mechanical fuel pump is part of the valve
cover and not serviced separately. Remove with
the valve cover. Disconnect the fuel lines at the
fuel pump fittings. See Figure 8-37. Properly
contain any remaining fuel.
Figure 8-33. Removing Stator.
4. Unhook the wiring harness from the molded
clips if it is being serviced separately. See Figure
8-34.
Figure 8-35. Removing Backing Shroud Mounting
Screws.
Remove Spark Plugs
1. Remove the spark plug from each cylinder head.
Figure 8-37. Disconnecting Fuel Lines.
Mounting
Screws
Molded Clips
Molded
Clip
Wiring
Harness
Molded
Clip
Backing
Shroud
Assembly
Screws
Screws
