7.17
Section 7
Electrical System and Components
7
3. Install the offset thrust (stop) washer so the
smaller offset of the washer faces the retainer/
collar. See Figure 7-34.
7. Install the backup washer, followed by the
rubber grommet, into the matching recess of the
drive end cap. The molded recesses in the
grommet should be
out
, matching and aligned
with those in the end cap. See Figure 7-36.
Thrust Washer
Figure 7-36. Installing Backup Washer and
Grommet.
8. Install the frame, with the small notch forward,
onto the armature and drive end cap. Align the
notch with the corresponding section in the
rubber grommet. Install the drain tube in the
rear cutout, if it was removed previously. See
Figure 7-37.
Figure 7-37. Installing Frame and Drain Tube.
Figure 7-34. Installing Thrust Washer.
4. Apply a small amount of oil to the bearing in the
drive end cap, and install the armature with the
drive pinion.
5. Lubricate the fork end and center pivot of the
drive lever with drive lubricant (see Section 2).
Position the fork end into the space between the
captured washer and the rear of the pinion.
6. Slide the armature into the drive end cap, and at
the same time seat the drive lever into the
housing.
NOTE
: Correctly installed, the center pivot
section of the drive lever will be flush or
below the machined surface of the
housing which receives the backup
washer. See Figure 7-35.
Figure 7-35. Installing Armature and Pivot Lever.
