8.13
Section 8
Disassembly
8
Remove Closure Plate Assembly
1. Remove the fourteen hex flange screws securing
the closure plate to the crankcase. See Figure
8-52.
Oil Pump Assembly
The oil pump is mounted to the inside of the closure
plate. If service is required, refer to the service
procedures under Oil Pump Assembly in Section 9.
Remove Camshaft
1. Remove the camshaft and shim (if used). See
Figure 8-55.
Figure 8-52. Removing Closure Plate Screws.
2. Locate the two protruding tabs on the closure
plate. Carefully tap to break the gasket seal. Do
not pry on the sealing surfaces as this could
cause leaks. Separate the closure plate from the
crankcase. See Figure 8-53 and 8-54. Remove the
old gasket.
Figure 8-53. Location of Tabs.
Figure 8-54. Removing Closure Plate.
Figure 8-55. Removing Camshaft.
Remove Connecting Rods with Pistons
and Rings
1. Remove the two hex flange screws securing the
closest connecting rod end cap. Remove the end
cap. See Figure 8-56.
Figure 8-56. Removing Connecting Rod Screws.
NOTE
: If a carbon ridge is present at the top of
either cylinder bore, use a ridge reamer
tool to remove the ridge before
attempting to remove the piston.
Tab
Tab
