10.16
Section 10
Reassembly
2. Mount the intake manifold to the cylinder heads.
Make sure the gaskets remain in the proper
position. Torque the four screws in two stages,
first to
16.9 N·m (150 in. lb.)
, finally to
22.6 N·m
(200 in. lb.
)
,
using the sequence shown in Figure
10-62.
Figure 10-64. Installing Valve and Spring to Cup.
Figure 10-62. Installing Intake Manifold
Figure 10-63. Intake Manifold Torque Sequence.
3. Install the carburetor mounting studs into the
intake manifold if previously removed. Use two
hex nuts, locked flange to flange, and tighten each
of the studs until bottomed/tight.
Install Oil Filter Housing Assembly
Reassemble the oil filter housing if disassembled
previously.
Reassembly
1. Install the small spring onto the rubber valve,
and insert the small end through the
corresponding hole in cup until properly seated.
See Figure 10-64.
2. Install the larger spring into the filter housing.
See Figure 10-65.
Figure 10-65. Installing Spring into Housing.
3. Insert the oil filter cup, aligning the cutout with
the corresponding section in the housing. See
Figure 10-66.
Cup
Valve
Spring
Spring
Figure 10-66. Installing Cup.
4. Install the nipple in housing and torque to
18.0 N·m (160 in. lb.)
. See Figures 10-67 and
10-68.
Cup
3
1
2
4
