10.21
Section 10
Reassembly
10
Torque the M6 screws going into the cylinder
head and crankcase to
10.7 N·m 95 in. lb.)
for
new holes, or
7.3 N·m 65 in. lb.
for used holes.
See Figure 10-84.
2. Align the oil cooler with the bosses in the
backing shroud assembly. Secure with the two
screws and washers. See Figure 10-86.
Figure 10-84. Installing Cylinder Baffles.
Install Oil Cooler
1. Connect the two hoses between the oil filter
adapter and oil cooler. Secure with new clamps.
See Figure 10-85.
Figure 10-85. Connecting Oil Cooler Hoses.
Figure 10-86. Installing Oil Cooler.
Install Cooling Fan and Grass Screen
CAUTION:
Failure to utilize or reassemble the grass screen as designed
could result in grass screen failure and serious personal injury.
1. Position the cooling fan onto the flywheel
aligning the mounting locations. Apply a small
amount of Loctite
®
No. 243 to the threads and
install the three long mounting screws. Torque
the screws to
9.9 N·m (88 in. lb.)
. See Figure
10-87.
Figure 10-87. Cooling Fan and Grass Screen
Assembly Details.
2. Apply a small amount of Loctite
®
No. 243 to the
external threaded section, (unless new parts
with preapplied locking compound are being
used). Thread the four grass screen hex studs into
the mounting holes in the flywheel. Torque each
stud to
9.9 N·m (88 in. lb.)
. See Figure 10-87.
Screws
Fan Screws
Mounting Studs
Stiffener
Grass Screen
Special Washers
Fan
Cylinder
Baffle
Mounting
Screws
Mounting
Screws
Hoses
Mounting Screws
