10.9
Section 10
Reassembly
10
Install Oil Pickup Screen
1. Apply a small amount of oil to the grommet of
the pickup screen and insert it onto the lower
end of pickup tube within the crankcase. Secure
the pickup to the boss on the bottom of
crankcase. Torque the mounting screw to
10.7 N·m (95 in. lb.)
into a new hole, or
7.3 N·m
(65 in. lb.)
into a used hole. See Figures 10-32 and
10-33.
Figure 10-34. Installing Oil Reservoir Gasket.
3. Install the oil reservoir onto the crankcase and
temporary alignment pins. The flywheel side is
indicated on the cover. Install and finger tighten
the screws. Remove the two alignment pins and
install the two remaining screws. Torque the
screws in the sequence shown in Figure 10-36 to
24.4 N·m (216 in. lb.)
.
Figure 10-32. Installing Pickup Screen.
Figure 10-33. Torquing Pickup Mounting Screw.
Install Oil Reservoir
1. Use two bolts with the heads removed, or a
similar item as temporary alignment pins and
install into the two center holes on the ends as
shown in Figure 10-34.
2. Install a new oil reservoir gasket onto the bottom
of the crankcase using the alignment pins. The
notched side of the gasket must be towards the
flywheel.
Mounting Screw
Pickup Screen
Pickup Tube
Figure 10-35. Torquing Oil Reservoir Fasteners.
Figure 10-36. Oil Reservoir Torque Sequence.
Temporary
Alignment Pins
Gasket
8
1
6
3
4
5
2
7
