10.22
Section 10
Reassembly
3. Install the stiffener followed by the metal grass
screen onto the four hex studs. Secure with the
four special washers and mounting screws using
Loctite
®
No. 243 on the threads. Torque the
screws to
9.9 N·m (88 in. lb.).
See Figure 10-87.
Install Electric Starter
1. Install the electric starter motor using the two
hex flange screws. See Figure 10-88.
2. Torque the two hex flange screws to
15.3 N·m
(135 in. lb.)
.
Torque the M6 screw going into the lower blower
housing mounting clip to
3.9 N·m (35 in. lb.)
. See
Figure 10-90.
Figure 10-88 Installing Electric Starter.
3. Connect the leads to the solenoid. See Figure
10-89.
Figure 10-89. Leads Connected to Starter.
Install Valley Baffles
1.
Install the two valley baffles and secure with the
mounting screws. The lower section should fit
under the outer baffle. Torque the M6 screws
going into the cylinder head to
10.7 N·m (95 in.
lb.)
for new holes, or
7.3 N·m (65 in. lb.)
for used
holes. Start the upper M6 screws only if the main
control bracket rear supports attach to the these
screws.
Figure 10-90. Installing Valley Baffles.
Install Carburetor
WARNING: Explosive Fuel!
Gasoline may be present in the carburetor and fuel system.
Gasoline is extremely flammable and its vapors can explode if
ignited. Keep sparks and other sources of ignition away from
the engine.
1. Install a new carburetor gasket onto the intake
manifold with the tab
up
. Make sure all holes
align and are open.
2. Attach the choke return spring and bracket to
the front hole in the choke lever on carburetor.
See Figure 10-91.
Figure 10-91. Choke Return Spring and Bracket
Details.
Valley Baffle
Mounting
Screws
Choke Return Spring and Bracket
Choke
Lever
