10.23
Section 10
Reassembly
10
3. Connect the throttle and choke linkages to the
carburetor if they were previously disconnected.
Install the carburetor with the linkages attached
as an assembly. See Figure 10-92.
Figure 10-94. Installing Control Bracket.
2. Connect the choke link to the control pivot pin.
Reinstall the washer and secure with a
new
push-on pal nut. See Figure 10-95.
Figure 10-92. Installing Carburetor with Linkages.
4. Connect the fuel line to the carburetor inlet and
secure with a clamp.
Install Governor Lever
1. Install the governor lever onto the governor shaft
and connect the throttle linkage with the black
clip. Do not tighten the governor lever at this
time. See Figure 10-93.
Figure 10-93. Installing Governor Lever.
Install Control Bracket and Air Cleaner
Assembly
1. Position the control bracket assembly onto the
two intake manifold bosses. Align the rear
supports with the top valley baffle/cylinder head
mounting screw locations and install the two
screws, but do not fully tighten. See Figure
10-94.
Figure 10-95. Installing Choke Link and Push-On
Nut.
3. Install a new air cleaner elbow gasket onto the
carburetor mounting studs.
4. Slide the air cleaner assembly onto the four
carburetor mounting studs. Align the two
forward mounting holes in the base with the
mounting holes/bosses of the intake manifold
and control bracket. Attach the ground lead
under the hex nut as originally installed. Install
the remaining three hex nuts and start the two
hex flange screws. Install the rear mounting
screws into the valley baffle/cylinder head.
Check the positions of all parts then torque the
four hex flange nuts to
7.9 N·m (70 in. lb.)
in the
sequence shown (Figure 10-98), and the four hex
flange screws to
9.9 N·m (88 in. lb.)
. See Figures
10-96, 10-97, and 10-98.
Rear Mounting
Locations
Control Bracket
Push-On Nut
Choke Link
Washer
Gasket
(Tab Up)
Throttle
Linkage
Choke
Linkage
Carburetor
Governor
Lever
Throttle Linkage
and Black Clip
