10.15
Section 10
Reassembly
10
Figure 10-57. Torquing Valve Cover Screw.
6. Install the oil fill cap onto valve cover (if
equipped).
Install Spark Plugs
1. Use new Champion® XC10YC (or equivalent)
spark plugs.
2. Set the gap at
0.76 mm (0.030 in.)
.
3. Install new plugs and torque to
24.4-29.8 N·m
(18-22 ft. lb.)
. See Figure 10-58.
Figure 10-59. Installed O-Rings on Crankcase and
Oil Filter Adapter.
2. Install the oil filter adapter onto the crankcase.
Install and torque the M8 capscrew to
24.4 N·m
(216 in. lb.)
. See Figure 10-60.
Figure 10-58. Installing Spark Plugs.
Install Oil Filter Adapter
1. Make sure all sealing surfaces are clean and the
three dowel pins are in place on the crankcase
adapter surface. Carefully install a new O-Ring
around each of the dowel pins. Then install three
new O-Rings onto the dowel pins of the oil filter
adapter. See Figure 10-59.
Figure 10-60. Torquing Oil Filter Adapter.
Install Intake Manifold
1. Install new intake manifold gaskets so the
notched section is inward and points toward the
flywheel side. See Figure 10-61.
Figure 10-61. Installed Intake Manifold Gaskets.
Mounting
Screw
Oil Filter
Adapter
O-Rings
O-Rings
Crankcase
Adapter
Notches
