![background image](http://html.mh-extra.com/html/kitchenaid/kgra806p/kgra806p_technical-education_198259028.webp)
4-2
REMOVING THE EOC ASSEMBLY ON SLIDE-IN &
FREESTANDING MODELS, AND THE USER INTERFACE
c) Open the oven door and remove the
indicated screws from the bottom of the
control panel.
1.
Unplug range or disconnect power.
2.
Turn off gas supply to range.
3.
Remove the two grates from the top of the
range.
4.
Pull the range forward so you can access
the two end cap screws.
5.
To remove the electronic oven control
(EOC) assembly on slide-in models:
a) Pull the knobs off the gas valves.
b) Remove the two screws from the sides
of the end caps.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Screw
Right
End Cap
Control Panel Screws
d) Pull out on the bottom of the control
panel, unclip the top edge from the
bracket, and rotate the control panel
forward so you can access the compo-
nents.
e) Disconnect the wire connectors from
the electronic oven control board at P1
and P2, and the ribbon cable connector
at P40.
f) Remove the four screws from the elec-
tronic oven control housing, and re-
move the assembly from the control
panel.
NOTE:
The EOC boards and the
housing are replaced as an assembly.
P1
P2
P40
EOC Housing
Screws
Pull
Out
Control Panel
Summary of Contents for KGRA806P
