background image

Quick Reference

Table of Contents:

If range does not operate:

Check that the circuit breaker is not tripped 
or the house fuse blown.

Check that the power supply cord is plugged
into the wall receptacle.

Check that gas line is turned on.

See Use and Care Guide for troubleshooting list.

If you need assistance:

If you have questions about operating, cleaning
or maintaining your range:

Refer to Use and Care Guide.

Call the Consumer Assistance Center. Check 
your Use and Care Guide for a toll-free 
number to call or call the dealer from whom 
you purchased this appliance. The dealer is 
listed in the Yellow Pages of your phone 
directory under “Appliances — Household —
Major — Service and Repair.”

If you need service:

Maintain the quality built into your range by
calling an authorized service company.
To obtain the name and number of an
authorized service company:

Contact the dealer from whom you 
purchased your range; or

Look in the Yellow Pages of your telephone 
directory under “Appliances — Household —
Major — Service and Repair;” or

Call the Consumer Assistance Center. 
The toll-free number is listed in your Use 
and Care Guide.

When you call, you will need:

The range model number.

The range serial number.

Both numbers are listed on the model/serial
rating plate located on the frame behind the
storage drawer.

Part No. 8523783
© 2002 Whirlpool Corporation

Printed in U.S.A.

Pages

2

2

2

3

3

4  - 7

7  -  8

Installation Instructions

IMPORTANT:

Installer: 

Leave Installation Instructions with the homeowner.

Homeowner: 

Keep Installation Instructions for future reference.

Save 

Installation Instructions for local electrical inspector's use.

Part No. 8523783

Moving the range:

8 8 8

When moving range, slide range onto cardboard
or hardboard to prevent damaging the floor
covering.

If removing the range is necessary for cleaning
or maintenance:

1. Remove the storage drawer.
2. Shut off the gas supply to the range.
3. Slide range forward, away from the wall, just

far enough to disconnect the gas and electric
supply lines.

4. Slide range forward to complete cleaning or

maintenance.

Benton Harbor, Michigan 49022

IMPORTANT:
Read and save these instructions.

If you need assistance:

Check your Use and Care Guide for a toll-free number to call or call
the dealer from whom you purchased this range. The dealer is listed
in the Yellow Pages of your phone directory under “Appliances —
Household — Major — Service and Repair.”
Call when you:

Have questions about range installation or operation.

Need to obtain the name and number of an authorized 
service company.

When you call, you will need:

The range model number.

The range serial number.

Both numbers are listed on the model/serial rating plate located on
the frame behind the storage drawer.

Before you start

Product dimensions

Cabinet dimensions/requirements

Electrical requirements

Gas supply requirements

Installation steps

Gas conversions

If range does not operate 

If you need assistance/service

Moving the range

Back cover

Back cover

Back cover

30" Freestanding

Sealed Burner

Gas

Range

with self-cleaning oven 

anti-tip
bracket

range foot

5.

Making sure the anti-tip bracket is installed:

• Look for the anti-tip bracket securely attached

to floor.

• Slide range back so rear range foot is under 

anti-tip bracket.

6. Check that range is level.
7. Reconnect gas line to range and check for

leaks.

8. Plug power supply cord into outlet. Reinstall

storage drawer.

Tip Over Hazard

A child or adult can tip the range and be
killed.

Connect anti-tip bracket to rear range
foot.

Reconnect the anti-tip bracket, if the
range is moved.

Failure to follow these instructions can
result in death or serious burns to
children and adults.

WARNING

Tip Over Hazard

A child or adult can tip the range and be
killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range
is moved.

Failure to follow these instructions can
result in death or serious burns to children
and adults.

WARNING

Summary of Contents for GS440LELB0










Reviews: