KitchenAid KGRA806P, Technical Education

Page: 30 / 84

4-4
5. To remove the standard ignition
switches:
NOTE: The standard ignition switches must be
replaced as an assembly. They cannot be
replaced individually.
a) Pull out on the standard ignition switches
and unsnap them from the gas valves,
then slide them off the valve stems.
b) Disconnect the ignition switch wire con-
nector from the main harness, cut the
wire tie, and remove the standard
switches.
REMOVING THE IGNITION SWITCHES, GAS VALVES,
AND CONTROL & COOLING FAN THERMAL SWITCHES
1. Unplug range or disconnect power.
2. Turn off gas supply to range.
3. Remove the two grates from the top of the
range.
4. Remove the control panel (see step 4 on
page 4-2 for the procedure).
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Control Thermal Sw. Cooling Fan Thermal Sw.
Right Gas Valves &
Ignition Switches
Left Gas Valves &
Ignition Switches
Standard
Ignition Switch
Ignition Switch
Connector
6. To remove the TripleTier

Crown Burner
ignition switch:
a) Disconnect the two wires from the igni-
tion switch terminals.
b) Remove the two screws from the igni-
tion switch and remove the switch from
the mounting plate.
Ignition Switch
Screws
TripleTier

Crown Burner
DISPLAY
BOARD
P2
W
P5-3
TRANSFORMER
W
L1
BK
BK
BK
P1
BK
KEYPAD
P2
TOD 130
°
C (266
°
F)
BK
THERMAL SW
OPENS @
96.1
°
C
±
3
°
C
(205
°
F
±
5.4
°
F)
LATCH MOTOR 4 W
OR
BR
GY
M
W
W
OVEN LIGHT
40 W
CONVECTION FAN 60 W
Y
OVEN LIGHT
40 W
P7-4
T3-2
T3-3
R/W
BU
BU/W
R/W
W
W
GY
T2-2
P4-7
P4-5
P4-4
M
P4-3
CONVECTION RING 1400 W
M
COOLING FAN 60 W
W
GY
BK GY
GY
THERMAL SW CLOSES @ 70
°
C
±
3
°
C
(158
°
F
±
5.4
°
F)
R/W
LATCH SW
P7-2
OR
HALO 1200 W
T2-3 W
W
R/W
N