FP 25 E
Operation
Issue: 06/2011
53
5
Operation and Troubleshooting
5 .1
Switch on and Start Projector / Stop and Switch off Projector
ATTENTION
Do not stand too close on rotating film spools, because clothes, hair or other parts of
your body can get winded up or trapped into the spools.
Switch on and start the projector
• Switch on the external power supply for the performance room.
• Switch on the main switch
(position “I”).
$
The switch illuminates red.
• Thread the film (see chapter 5.2).
• Push the button
.
$
The projector is running, the ventilation is on, the xenon lamp is on.
• If necessary push the button
on the projector’s operating panel, after the start
leader has run through.
X
NOTE
Immediate after the projector is switched on you must not manually turn the intermittent
sprocket (e. g. for film threading) until the projector initialization is completed.
Stop and switch off the projector
• To stop the projector manually push the STOP button and close the dowser by push-
ing
.
$
The dowser closes, the xenon lamp gets off, the projector stops and the ventilation is
on (if the temperature is more than 60° C).
• Switch off the main switch
(position “0”).
$
The key lamp turns off.
• Switch off the external power supply for the performance room.
X
NOTE
Z
If you have an emergency stop, push the main switch
(position “0”), to cut the
power.
Z
If the film is run through the projector stops due to the film break sensor.
Summary of Contents for FP 25 E PREMIERE
