Kia Carnival, Manual

Page: 771 / 828

85
8
8
Maintenance Light bulbs
8. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
9. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assem
-
bly and turn the socket clockwise.
10.Install the rear combination lamp
assembly to the body of the vehi
-
cle.
11.Install the service cover.
Replacing stop and tail lamp (LED
type)
If the stop and tail lamp (1) do not
operate, have your vehicle checked
by a professional workshop. Kia rec
-
ommends to visit an authorised Kia
dealer/service partner.
The LED lamp cannot be replaced as
a single unit because it is an inte
-
grated unit. The LED lamp has to be
replaced with the unit.
A skilled technician should check or
repair the stop and tail lamp (LED),
for it may damage related parts of
the vehicle.
Replacing back up lamp (Bulb type)
1. Remove the plastic tabs with a
flat-tip screw driver.
2. Loosen the plastic retaining
screws and remove the under
panel cover.
3. Disconnect the rear back up lamp
connector (A).
4. Remove the socket (A) from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
6. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
OKA4071042
OKA4070044