29
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Spine Screen 10-Wire Power
Assembly Instructions
Spine
Screen
(#1)
Spine
Screen
(#2)
base infeed
spacer (in-line)
10-wire
rigid wireway
10-wire base
power infeed
screen-to-screen
10-wire jumper (21 / ”)
1
4
10-wire
rigid wireway
Flex
Screen
Figure 29
Spine
Screen
Spine
Screen
base infeed
spacer (in-line)
spacer
cover
spacer
cover
channel
molding
clip
10-wire base
power infeed
Flex
Screen
Figure 30
Detail OO
spacer
cover
molding
clip
spacer cover
channel
7. At the location specified for a
screen-to-screen jumper between
the base infeed spacer, route the
jumper through the pass-through
ankles at each end of the Spine
Screen, then plug the ends into
each rigid wireway of the powered
Spine Screens (Figure 29).
8. Route the 10-wire base power
infeed plug end of the infeed
through the pass-through ankle and
plug it into an open end of a
10-wire rigid wireway (Figure 29).
9. On the rib side of the spacer cover,
space molding clips evenly apart
and press them onto the ribs of the
cover (Figure 30 & Detail OO).
10. Position the spacer cover with
molding clips up against the spacer
cover channel with the 10-wire base
infeed routed through the opening
at the bottom of the spacer cover.
Using a firm hand, press on the
spacer cover at the molding clip
locations to snap molding clips into
the spacer cover channel (Figure 30
& Detail OO).
11. Reference “Leveling and
Connecting Spine Screens”
instructions on page 6 to connect
remaining screens.
