11
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Spine Screen 10-Wire Power
Assembly Instructions
Figure 7
pass-through
ankles
pass-through
screen-to-screen
10-wire jumper
10-wire
rigid wireway
Spine Screen
(powered)
Spine Screen
(non-powered)
Spine Screen
(powered)
pass-through
ankles
Detail M
Spine Screen
(powered)
pass-through
screen-to-screen
10-wire jumper
pass-through
ankles
10-wire
rigid wireway
Spine Screen
(non-powered)
Pass-Through Screen-to-Screen
10-Wire Jumper Installation
Note:
Pass-through screen-to-
screen jumpers pass power from one
powered Spine Screen through an
unpowered Spine Screen to another
powered Spine Screen. Pass-through
screen-to-screen jumpers length
are equal to the length of the
non-powered Spine Screen plus an
additional 17
3
/
4
”.
1. At the location specified for a
pass-through screen-to-screen
jumper, route the jumper through the
pass-through ankles at each end of
the non-powered screen, then plug
the ends into each rigid wireway of
the powered Spine Screens (Figure 7
& Detail M).
