13
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Spine Screen 10-Wire Power
Assembly Instructions
6. Determine the length of the inner
vertical trim by measuring the
distance from the ceiling to the top
of the Spine Screen frame. Next,
determine the length of the outer
vertical trim by measuring from
the ceiling, down to the floor at the
outer trim location. Then, squarely
cut the inner and outer vertical trim
section to the measured lengths
above (Figure 9).
7. On the rib side of the inner and
outer vertical trim, space molding
clips evenly apart and press them
onto the ribs of the vertical trim as
illustrated (Figure 9 & Detail O).
8. Position the inner and outer vertical
trim with molding clips up against
the appropriate side of the top
infeed power pole channel. Using
a firm hand, press the trim at the
molding clip locations to snap into
the power pole channel (Figure 9 &
Detail O).
9. Place the 10-wire top infeed
conduit inside the power pole and
route the plug end of the infeed
down through the pass-through
ankle and plug it into the end of the
10-wire rigid wireway (Figure 9).
10. Push the 10-wire end of the
power infeed up through the top
of the power pole and into the
above-ceiling area for later
connection to the source power (by
a certified electrician) (Figure 9).
11. Determine the length of the
top infeed power pole cover by
measuring the distance from the
ceiling to the floor at the side of the
infeed power pole. Cut the cover
square to the marked length
(Figure 9).
12. On the rib side of the power pole
cover, space molding clips evenly
apart and press them onto both ribs
on the cover as illustrated
(Figure 9 & Detail P).
13. Position the power pole cover
with molding clips up against the
opening side of the end-of-run
top infeed power pole. Using a
firm hand, press the cover at the
molding clip locations to snap into
power pole cover channel
(Figure 9 & Detail P).
Figure 9
Spine
Screen
10-wire top
power infeed
exposed
10-wires
top infeed
power pole
(end-of-run)
inner
vertical trim
power pole
cover
10-wire
rigid wireway
outer
vertical trim
pass-through
ankle
molding
clip
molding
clips
molding
clip
Detail O
vertical
power pole
channel
outer
power pole
vertical trim
molding
clip
Detail P
power pole
cover
power pole
cover
channel
molding
clips
power pole
cover
channel
