17
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Wide Screens - Spine Screen 10-Wire Power
Assembly Instructions
Note:
All screens must be
mechanically connected together,
with all 10-wire rigid wireways and
screen-to-screen power connections
appropriately installed before adding
power infeed, or connecting infeed to
power source.
Note:
The power infeeds are to be
connected to the power source by
a qualified electrician who must
follow all state and local codes at the
building site and check the electrical
integrity of the finished system.
7. Carefully lift and arrange Spine
Screen #2 so that the adjustable foot
is over the foot of the Flex Screen
(Detail U). Move Spine Screen #2
over to align its installed screen
connector/clips with the appropriate
power pole channel. Level and plumb
Spine Screen #2 to #1 by twisting the
height-adjustable glides clockwise or
counter-clockwise until the frame’s
vertical edges are aligned and tops of
screens are at the same height. Press
Spine Screen #2 screen connector/
clips into the power pole channel
to engage such that both Spine
Screens are snapped into the in-line
top infeed power pole (Figure 13 &
Detail V).
Spine
Screen
(#1)
Spine
Screen
(#2)
top infeed
power pole
(in-line)
vertical
power pole
channel
screen
connector
molding
clip
Flex
Screen
bridge
foot
adjustable
glide foot
Figure 13
screen
connector
molding clip
(factory installed)
Spine
Screen
vertical
frame
channel
vertical
power pole
channel
top infeed
power pole
(in-line)
Detail V
Detail U - Spine Screen 3-Way
Intersection with Flex Screen
(adjustable feet over bridge foot)
bridge
foot
adjustable
glide feet
Flex
Screen
Spine
Screen
