47
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Topper
Assembly Instructions
Topper Kit Installation
Note:
Flex screens ship assembled
with flat aluminum top caps installed
except when topper kits are specified.
1. On the rib side of the topper
connector, space molding clips
evenly apart and press them onto the
ribs of the connector as illustrated
(Figure 1).
2. Position the topper connector with
molding clips up on top of the
horizontal frame channel. Using
a firm hand, press the topper
connector down at the molding clip
locations to snap molding clips into
the horizontal frame channel
(Figure 1).
Note:
Cork adhesive backed gasket
is wrapped around the bottom at the
end, and middle of acrylic toppers at
the plant. Do not remove gasket as
it is required for installation of the
acrylic topper to the connector.
3. Set and center the acrylic or felt
topper into the top opening on the
topper connector and press down
securely (Figure 1).
Figure 1
Flex Screen
or Spine Screen
(non-powered)
molding
clip
acrylic/felt
topper
topper
connector
horizontal
frame
channel
horizontal
frame
cork
adhesive
backed
gasket
