37
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Spine Screen Trim
Assembly Instructions
7. At the location specified for a
screen-to-screen jumper between
the spacer, route the jumper
through the pass-through ankles
at each end of the Spine Screen,
then plug the ends into each rigid
wireway of the powered Spine
Screens (Figure 41).
8. Route the 10-wire base power
infeed plug end of the infeed
through the pass-through ankle and
plug it into an open end of a
10-wire rigid wireway (Figure 41).
9. On the rib side of the spacer cover,
space molding clips evenly apart
and press them onto the ribs of the
cover (Figure 41 & Detail BBB).
10. Position the spacer cover with
molding clips up against the spacer
cover channel with the 10-wire base
infeed routed through the opening
at the bottom of the spacer cover.
Using a firm hand, press on the
spacer cover at the molding clip
locations to snap molding clips into
the spacer cover channel (Figure 42
& Detail BBB).
11. Reference “Leveling and
Connecting Spine Screens”
instructions on page 6 to connect
remaining screens.
Spine
Screen
(#1)
Spine
Screen
(#2)
spacer
(in-line)
10-wire
rigid wireway
screen-to-screen
10-wire jumper (21 / ”)
1
4
10-wire
rigid wireway
Flex
Screen
Figure 41
Spine
Screen
Spine
Screen
spacer
(in-line)
spacer
cover
spacer
cover
channel
molding
clip
10-wire base
power infeed
Flex
Screen
Figure 42
Detail BBB
spacer
cover
molding
clip
spacer cover
channel
