40
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo™
Screens - Spine Screen Trim
Assembly Instructions
Change-of-Height Trim
Installation
1. Per the space-planning layout, locate
the change-of-height screens. Make
sure that screens are plumb and
level.
2. Determine the length of the vertical
trim for the change-of-height screens
by measuring the distance from the
bottom of the vertical frame of the
taller Spine Screen, down to the top
of the lower Spine Screen frame at
the vertical trim location. Cut the
vertical trim to the marked length.
3. On the rib side of the vertical trim,
space molding clip(s) evenly apart
and press them onto the rib of the
vertical trim as illustrated
(Figure 45).
4. Position the vertical trim with
molding clip(s) up against the
vertical frame channel. Using a
firm hand, press on the trim at the
molding clips to snap molding
clips into the vertical frame channel
(Figure 45).
5. Place the end-of-run corner cap into
the notch formed on the top corner
of the horizontal frame. Align the
mounting holes on the horizontal
frame with the mounting holes on
the corner cap and secure with two
#10-24 x
3
/
8
” Torx screws
(Figure 45).
Note:
If Spine Screen is specified
with a topper kit and no Flex
Screen configurations are required,
proceed to page 47 for “Topper
Kit Installation” instructions. If
Flex Screen configurations will
be configured with Spine Screen
configurations and topper kits
are specified, proceed to page 42
for “Flex Screen Configurations”
instructions. If Spine Screen are not
specified with topper kits proceed to
“Flat Aluminum Top Cap Installation”
instructions on page 41.
Spine Screen
Spine Screen
Figure 45
vertical
trim
molding
clip
end-of-run
corner
cap
#10-24 x / ”
Torx screws
3
8
vertical
frame
channel
vertical
frame
horizontal
frame
