SENSe Subsystem
9
[SENSe:]LRESistance:RANGe:AUTO
U3606A Programmer’s Reference
215
[SENSe:]LRESistance:RANGe:AUTO
Syntax
[SENSe:]LRESistance:RANGe:AUTO <mode>
This command disables or enables autoranging for 4- wire low- resistance
measurements. Autoranging is convenient because the instrument
automatically selects the range for each measurement based on the input
signal detected.
[SENSe:]LRESistance:RANGe:AUTO?
This query returns a boolean value that represents the 4- wire
low- resistance autoranging setting:
0
or
1
Parameter
Remarks
•
Autorange thresholds:
Down range at: <10% of range
Up range at: >120% of range
•
With autoranging enabled, the instrument selects the appropriate range
based on the input signal detected.
•
Selecting a discrete range (see
“[SENSe:]LRESistance:RANGe[:UPPer]” on page 213
) will disable
autoranging.
•
The instrument enables autoranging after a Factory Reset (
*RST
command).
•
For measuring low- resistance a delayed response should be expected
from the front panel display. For remote interface operation, increase
the SCPI query timeout value. (Typically 15000 ms.)
Item
Type
Range of values
Default value
auto
Boolean
0|1|OFF|ON
1
Summary of Contents for U3606A
