TRIGger Subsystem
13
TRIGger:SOURce
U3606A Programmer’s Reference
311
Remarks
•
After selecting the trigger source, you must place the instrument in the
“wait- for- trigger” state by using the
INITiate[:IMMediate]
command
or
READ?
query. A trigger will not be accepted from the selected trigger
source until the instrument is in the “wait- for- trigger” state.
•
The
CONFigure
commands and
MEASure?
queries automatically sets
the trigger source to
IMMediate
.
•
For the
IMMediate
(continuous) source, the trigger signal is always
present. When you place the instrument in the “wait- for- trigger” state,
the trigger is issued immediately.
•
For the
BUS
(software) source, the instrument is triggered by the
*TRG
command received over the remote interface. The
*TRG
command will
not be accepted unless the internal instrument is in the
“wait- for- trigger” state.
•
The instrument selects the
IMMediate
trigger source after a Factory
Reset (
*RST
command) or an Instrument Preset (
SYSTem:PRESet
command).
•
If the selected trigger source is invalid due to a settings conflict, the
source reverts automatically to
IMMediate
. A settings conflict error
message is also generated.
N O T E
The
INITiate[:IMMediate]
command only initiates the
measurement and needs a trigger (
BUS
or
IMMediate
) to make the
actual measurement.
Summary of Contents for U3606A
