CALibration Subsystem
3
Remote Calibration Procedures
U3606A Programmer’s Reference
65
Resistance gain adjustment procedures
Follow the steps outlined below. Review the “Test Considerations”
described in the
U3606A User’s and Service Guide
and the
adjustment considerations” on page 59
before beginning this test.
Calibration step
Remote command
Resistance gain adjustment — Short
1
Select the 2-wire resistance measurement.
Connect a shorting plug between the
Ω
(red) and
LO
(black) input terminals.
&
CONF:RES
2
Calibrate the zero point for 2-wire resistance
measurements.
&
CAL:VAL 0
3
Start the calibration.
&
CAL?
Resistance gain adjustment — Open
4
Remove the shorting plug from the input
terminals (all terminals open). Select the
100 M
Ω
range.
&
CONF:RES 100M
5
Calibrate the open point for 2-wire
resistance measurements.
&
CAL:VAL 9.9E+37
6
Start the calibration.
&
CAL?
Resistance gain adjustment — 10 M
Ω
7
Select the 10 M
Ω
range. Input 10 M
Ω
resistance to the
Ω
(red) and
LO
(black)
input terminals.
&
CONF:RES 10M
8
Calibrate the 10 M
Ω
point for 2-wire
resistance measurements.
&
CAL:VAL 10M
9
Start the calibration.
&
CAL?
N O T E
If the zero offset adjustment procedure has been recently
performed prior to the resistance gain calibration procedure, the
adjustment item “Short” and “Open” can be omitted.
Summary of Contents for U3606A
