4
CONFigure Subsystem
CONFigure:PWIDth
114
U3606A Programmer’s Reference
CONFigure:PWIDth
Syntax
CONFigure:PWIDth
This command first resets all pulse width measurement parameters and
trigger parameters to their default values. Then, it configures the
instrument for pulse width measurements but does not initiate the
measurement.
There are two measuring paths for the pulse width measurement — voltage
or current. Therefore, before setting the frequency measurement, you have
to configure the voltage (see
“CONFigure[:VOLTage]:AC” on page 84
current (see
“CONFigure:CURRent:AC” on page 93
) measurements first.
Remarks
•
This command also sets the trigger source to “immediate” and clears all
calculation functions.
•
When no signal is applied, “
0
” is returned.
•
Autorange thresholds:
Down range at: <10% of range
Up range at: >120% of range
N O T E
•
The range and resolution of the pulse width measurement follows the
configuration of the AC voltage or the AC current function.
•
The
CONFigure:PWIDth
command does not place the instrument in
the “wait-for-trigger” state. Use the
INITiate[:IMMediate]
or
READ?
command in conjunction with the
CONFigure:PWIDth
to
place the instrument in the “wait-for-trigger” state.
C A U T I O N
If the frequency signal measured is below 20 Hz, you must manually
set the range of the AC voltage or AC current measurement to acquire
a stable reading.
Summary of Contents for U3606A
