Keysight U3606A, Programmer'S Reference Manual

Page: 227 / 372

SENSe Subsystem 9
[SENSe:]LRESistance:RANGe[:UPPer]
U3606A Programmer’s Reference 213
[SENSe:]LRESistance:RANGe[:UPPer]
Syntax
[SENSe:]LRESistance:RANGe[:UPPer] {<range>|MIN|MAX|DEF}
This command selects the measurement range for 4- wire low- resistance
measurements.
[SENSe:]LRESistance:RANGe[:UPPer]? [{MIN|MAX}]
This query returns a numeric value that represents the 4- wire
low- resistance measurement range.
Parameter
Remarks
•
Selecting a discrete range will disable autoranging.
• If the input signal is greater than can be measured on the selected
range (manual ranging), the instrument gives an overload indication.
• Positive overload: “ +9.37 ” or “OL” from the front panel.
•
Negative overload: “ -9.37 ” or “–OL” from the front panel.
• If a range change is in progress (due to the autoranging setting) when
you query the instrument, the value “
+9.37 ” will be
returned. Wait for the instrument to select an appropriate range before
querying the instrument again.
• The instrument is set to 100 m
Ω
, with autoranging enabled, after a
Factory Reset ( *RST command).
•
For measuring low- resistance a delayed response should be expected
from the front panel display. For remote interface operation, increase
the SCPI query timeout value. (Typically 15000 ms.)
Item Type Range of values Default value
range Numeric • 100 m
Ω
|MIN
• 1000 m
Ω
• 10
Ω
|MAX
• DEF (AUTO)
MIN