Figure 9
Port 1 Configuration
Port 1 Configuration
2-Port Setup
M9374A Module #1 with VDI Extender #1
Cable
Type
1
RF/LO
RF/LO
IF
M9374A
Module #1
VDI
Extender #2
Port 1
LO Out
to
Port 2
RF/R
LO-I
M
Figure
Reference
Table 7
Port 1 Configuration Cable Connections
A
C
B
A
B
C
1. Remove the 50 ohm load from LO Out on M9374A Module #1.
2. Install the three cables between M9374A Module #1 and VDI Extender #1. See
Table 7
and
Figure 9
.
3. If not already installed, install a 50 Ω load to LO In on M9374A Module #1. See
Figure 9
.
4. Connect VDI Extender #1 (LO-O) to VDI Extender #2 (LO-I) with an RF/LO cable. See
Figure 9
.
5. Connect the power cord to VDI Extender #1. See
Figure 9
.
to
to
1. RF/LO cables are thicker then the IF cables and are marked RF/LO or IF at the end of the cables.
18
N5252-90002 User's Guide
Summary of Contents for N5252A
