Keith McMillen Instruments K-MIX, User Manual

Page: 75 / 156

K-M
IX
H
ARDWARE
64
• Rotary 2 = Mid Boost/Cut
• Rotary 3 = Mid Frequency
• Rotary 4 = High Boost/Cut
It is also possible to hold down the [SHIFT] button to access more EQ parameters. When holding
down [SHIFT] the rotaries will adjust the following parameters:
• Rotary 1 = Low Frequency
• Rotary 2 = off
• Rotary 3 = Mid Q (Bandwidth)
• Rotary 4 = High Frequency
Rotaries act like traditional knobs; the minimum value is at 7 o’clock and the maximum value is at
5 o’clock. Move the rotary clockwise to increase the current parameter’s value; move the rotary
counterclockwise to decrease.
C
HANNEL
S
ELECT
B
UTTON
B
EHAVIOR
The channel select buttons are used to select the EQ that is currently being edited by the rotary
controls.
• Each input channel and the main output bus has its own EQ, so any of the channel select
buttons may be used.
The LED color of the channel select buttons is used to display the currently selected EQ (or EQs).
• Green = currently selected
• Red = not selected
When selected, the rotaries will update to display the selected channel’s EQ settings.
4.2.15.2 – A
DJUSTING
EQ S
ETTINGS
To edit a channel’s EQ settings, do the following:
1. Press the [EQ] button to go into EQ mode.
2. Press one of the channel select buttons to select a channel to edit. The currently selected channel
will light up green — all others are red. The rotary LEDs will immediately snap to the selected
channel’s EQ settings.
3. Adjust any of the four rotaries to adjust the EQ settings.
4.2.15.3 – [SHIFT] F
UNCTIONALITY
When in EQ Mode, the [SHIFT] button is used to access the extra parameters from the rotaries — Low
Frequency, High Frequency, and Mid Q (Bandwidth).
When [SHIFT] is held down, rotary 1 controls Low Frequency, rotary 3 controls Mid Q, and rotary 4
controls High Frequency. Rotary 2 has no [SHIFT] functionality.