Keith McMillen Instruments K-MIX, User Manual

Page: 121 / 156

K-M
IX
E
DITOR
110
5.2.2.1 – B
YPASS
B
UTTON
The bypass button enables or disables the reverb effect.
• Clicking the button will toggle the state of the bypass.
• The button will light up
green when enabled (reverb on).
• The button will go dark when disabled (reverb bypassed).
5.2.2.2 – C
HANNEL
S
END
L
EVELS
Sets the amount of signal to send into the reverb. Each input channel has its own send level.
S
END
L
EVEL
K
NOBS
& N
UMBER
B
OXES
Sets the reverb send levels for each of the eight input channels.
• Turn clockwise to increase the send level (more signal going to the reverb); turn
counterclockwise to decrease the send level (less signal going to the reverb).
• A specific value may be entered into the accompanying number boxes as an alternative way of
setting the reverb send levels.
• Range : -70dB – +6dB
P
RE
/P
OST
F
ADER
S
WITCH
Sets whether the reverb sends are pre-fader or post-fader.
• When set to “Post”, both the channel’s volume fader and the reverb send level affect the amount
of signal sent to the reverb; the signal is tapped after the fader.
• When set to “Pre”, only the reverb send level affects the amount of signal sent to the reverb; the
signal is tapped before the fader so it has no effect.
• The pre/post switch is a global switch; it acts on all eight channels simultaneously. It is not
possible to set pre/post on a per-channel basis.
Below is a diagram illustrating the pre/post switch on channel 1 (currently set to “Pre”):
Channel 1
Input Audio
To Outputs
To Reverb
1
Pre-Fader
Pre/Post
Switch
Reverb
Send Level
Post-Fader
Channel 1
Volume Fader