Kato SR-300L, Instruction Manual

Page: 189 / 233

- 173 -
1) Recheck the working area.
Check again that the ground in the area where you are going to perform pick and carry operation is firm and
level.
If the ground is crumbly or muddy, pick and carry operation will not be possible there.
2) Recheck the rated lifting capacity chart.
Recheck the rated load, boom length and other conditions for the pick and carry operation and perform
according to the values in the relevant rated lifting capacity chart.
3) Recheck the tire pressure.
4) Lock the suspension.
Lock the suspension with the cylinders fully retracted.
5) Set the ACS working status.
Set the "pick and carry operation" on the "working status setting
screen".
Any mistake in setting the ACS working status can be extremely
dangerous.
6) Apply the slewing brake to immobilize the superstructure.
7) Use the high/low speed switch on the switch panel to select "low range" and move the shift lever to speed 1.
8) When you have finished setting the ACS working status, proceed with crane operation.
Crane operation while in motion is forbidden. If you must lift the load just off the ground and
clear any irregularities on the ground surface, stop the crane, apply the parking brake and hoist
the load sufficiently to avoid any obstacles.
If this operation leaves the load hoisted a long distance above the ground, lower it back down
close to the ground as soon as possible.
(541A-0201-2E)