Kato SR-300L, Instruction Manual

Page: 178 / 233

- 162 -
16-5-2 Outrigger stowage procedure
(061A-0080-3E)
When you are going to stow the outriggers, always set the superstructure to the driving position as shown in the
diagram below.
(1) Check that the outrigger operation OK indicator lamp is lit.
Conditions for lighting
・
If the crane position is in a boom length and boom angle as indicated on the capacity chart for pick and carry
operation.
・
If the ACS boom operation status is set to "jib setting".
(2) Extract all four stopper pins from the outriggers.
If you cannot take an outrigger stopper pin out, retract the vertical cylinder first. Once it is fully
retracted, extend (or retract) the outrigger beam until you can take the pin out.
(591A-0089-1E)