Karel DS200, Technical Reference And Installation Manual

Page: 208 / 222

198
XVIII. HOW TO PUT THE SYSTEM INTO
SERVICE
After all the cards have been installed, the system is ready to be powered.
The methods for powering the system properly have been listed below for different system
configurations:
XVIII.1. DS200
XVIII.1.A. WALL-TYPE SYSTEMS WITH SINGLE RACK
1) One makes sure the entire cables in the rack have been connected properly.
2) The mains and battery switches on the SPS200 module are checked to see whether
they are off.
3) The mains cord is connected to the SPS200 module and then it is plugged into an
outlet of the premise that has been grounded correctly.
4) The batteries are connected (if battery connection is to be made) to the battery
connectors of the SPS200 module.
5) The mains switch on the SPS200 module is turned on.
6) The battery switch on the SPS200 module is turned on.
XVIII.1.B. WALL-TYPE SYSTEMS WITH TWO RACKS
1) One makes sure the entire intra-rack and inter-rack connections have been made
properly.
2) The mains and battery switches on the entire SPS200 modules are checked to see
whether they are off.
3) The mains cords are connected to the SPS200 modules and then they are plugged
into an outlet of the premise that has been grounded correctly.
4) The batteries are connected (if battery connection is to be made) to the battery
connectors of the first SPS200 module. (Keep in mind that no connection shall be
made to the second SPS200 module.)
5) The mains switches on the SPS200 modules are turned on.
6) The battery switch that is on the SPS200 module to which the batteries have been
connected is turned on.