Karel DS200, Technical Reference And Installation Manual

Page: 151 / 222

DS Series PBX Technical Reference And Installation Guide
141
XII.2. DS200S
1- A location that complies with the requirements stated in the preparation step is plotted.
2- By making use of the mounting template that comes with the DS200S rack, the locations
for the wall mount bars that are to be used for hanging the racks on the wall are marked
carefully. The
3- lower hole of the wall mount bars should be approximately 130 cm. above the floor. It is
essential to check whether the height of both right and left holes are the same, in order to
make sure the exchange is parallel to the floor.
4- The anchor plugs are driven into the holes, correctness of whose locations have already
been verified, and then the wall mount bars are screwed. One must keep in mind that the
right and the left sides of the wall mount bars differ. The screws must be tightened
enough to be inserted entirely into the wall.
5- After removing the front cover of the exchange by unscrewing the Allen screws, the
bottom cover is removed by sliding it towards the front.
6- While removing the bottom cover, one must watch out for the grounding cables that are
between the cover and the main frame, so that they should not break off. The cables
should be removed from the covers together with their tags and safely kept away against
any damage during the installation.
7- The SPS200S is pulled out towards the front and removed. (This operation is just for
facilitating the installation and not obligatory.)
8- The exchange is held against the wall so that the wall mount bar holes on the back of the
exchange corresponds to the wall mount bar holders, then the exchange is pushed
towards the wall to let the holders carry it. After one makes sure that the holders of both
wall mount bars have been inserted into the holes, the exchange is lowered cautiously.
The exchange is supposed to halt at its final position 5 mm. below. If it is still not fixed
even though it has been lowered for about one centimeter, then that indicates the holders