Karel DS200, Technical Reference And Installation Manual

Page: 185 / 222

DS Series PBX Technical Reference And Installation Guide
175
XV.3.K. EX200 (8VoIP) VOICE OVER IP MODULE:
Since the EX200 (8VoIP) card is to be treated as a standard network component, it is
connected over a standard Ethernet cable to a switch or hub, which is part of an existing
computer network.
Pinouts for connection of the EX200 (8VoIP) card are as in the table below (the Ethernet
standard):
Signal RJ45 pin no
RX-1 1
RX-2 2
TX-1 3
TX-2 6
Order of the 4 wires in the cable mentioned above matters, which are to be used for the
Ethernet connection.
The EX200 (8VoIP) cards, which are to be employed for servicing IP telephones are
supposed to be installed in consecutive card slots in the exchange.
Range of the Ethernet cable (CAT5 UTP), which has been attached to the VoIP card, can
extend up to 80 meters. That distance can be increased by employing hubs or switches.
XV.3.L. EX200 (16VoIP) VOICE OVER IP MODULE:
Since the EX200 (16VoIP) card is to be treated as a standard network component, it is
connected over a standard Ethernet cable to a switch or hub, which is part of an existing
computer network.
Pinouts for connection of the EX200 (16VoIP) card are as in the table below (the Ethernet
standard):
Signal RJ45 pin no
RX-1 1
RX-2 2
TX-1 3
TX-2 6
Order of the 4 wires in the cable mentioned above matters, which are to be used for the
Ethernet connection.
The EX200 (16VoIP) cards, which are to be employed for servicing IP telephones are
supposed to be installed in consecutive card slots in the exchange.
Range of the Ethernet cable (CAT5 UTP), which has been attached to the VoIP card, can
extend up to 80 meters. That distance can be increased by employing hubs or switches.