Karel DS200, Technical Reference And Installation Manual

Page: 207 / 222

DS Series PBX Technical Reference And Installation Guide
197
XVII. FINAL PREPARATIONS
XVII.1. DS200M/DS200S/DS200:
Upon completion of all those operations explained in previous pages, a computer should be
connected to the system, in which the IDEA software has been installed. For this purpose,
one end of the computer cable that comes with DS200 is supposed to be connected to the
RS232 port on the DS200 CPUKON card. The other end of the cable is supposed to be
connected to the serial port of the computer.
In addition to that, an LT200 (-H) or FT20 Feature Telephone set should be connected as the
operator telephone in order to watch the tests closely that are to be carried out on the
system. For this purpose, the two-pin end of the cable, which comes with DS200 with a two-
pin connector at one end and a telephone connection box at the other, should be plugged
into one of the KTS ports that are available on the DS200 CPUKON card, and then the first
extension of the first extension card (blue-white pair) should be connected to the red and
green ends of the connection box that is at the other end of that cable. The connection
between that box and the telephone should be made with the cable that comes with the
telephone and that has RJ11 jack at both ends.
Details about those connections have been explained in the guides of the related telephones
and in the IDEA program guide.
XVII.2. DS200L
After the steps pertaining to the installation of the DS200L system has been completed, the
programming work pertaining to the system and the DCC block is done with the maintenance
computer by using the program IDEA. To do that, the PCU200 computer, the maintenance
computer and the DCC block are supposed to have been connected to the same network
switch and they are supposed to have been defined in the same local area network (LAN), as
previously specified.