Karel DS200, Technical Reference And Installation Manual

Page: 194 / 222

184
XV.3.T. EX200 (MGW1) MEDIA GATEWAY MODULE:
Since the EX200 (MGW1) card is to be treated as a standard network component, it is
connected over a standard Ethernet cable to a switch or hub, which is part of an existing
computer network.
Pinouts for connection of the EX200 (MGW1) card are as in the table below (the Ethernet
standard):
Signal RJ45 pin no
RX-1 1
RX-2 2
TX-1 3
TX-2 6
Order of the 4 wires in the cable mentioned above matters, which are to be used for the
Ethernet connection.
Range of the Ethernet cable (CAT5 UTP), which has been attached to the MGW1 card, can
extend up to 80 meters. That distance can be increased by employing IP switches.
XV.3.U. EX200 (MGW2) ADVANCED MEDIA
GATEWAY MODULE:
Since the EX200 (MGW2) card is to be treated as a standard network component, it is
connected over a standard Ethernet cable to a switch or hub, which is part of an existing
computer network.
Each media gateway channel add-on card is installed into SODIMM connector on the card.
And each black-fin module has its own Ethernet connector the pin-out of which is given
below:
Signal RJ45 pin no
RX-1 1
RX-2 2
TX-1 3
TX-2 6
Order of the 4 wires in the cable mentioned above matters, which are to be used for the
Ethernet connection.
Range of the Ethernet cable (CAT5 UTP), which has been attached to the MGW2 card, can
extend up to 80 meters. That distance can be increased by employing IP switches.