Kambrook KSB400, Instruction Booklet

Page: 15 / 44

14
HINT:
Pinch the top and bottom
of each clip between thumb and
index finger and pull outwards to
release locking clips.
NOTE:
The cube cutter blade
will only sit inside the blade
holder when fitted in the correct
position.
Fig. 4
2. Hold the blade disc only by the
plastic part to avoid the sharp
blade. Turn the disc so the sharp
side of the blade is facing up and
drop the protruding cylinder on
the blade disc into the hole of the
blade holder (See Fig. 5). Make
sure the disc fits securely inside
the blade holder and then push
the four locking clips towards the
blade holder edges to lock the
disc in place for dicing.
Fig. 5
3. Place the food processing
bowl on a flat benchtop and
remove the lid. To do this, press
downwards on the lid release
button found on the handle of
the processing bowl to release
and twist the lid clockwise to
unlock. Remove the lid from
the bowl.
4. Locate the small vertical tab
found on the inside of the
processing bowl just to the left of
the handle near the top edge.
Align the small groove on the
blade holder with the vertical
tab. Once aligned, drop the
assembled cubic attachment
inside the processing bowl. Make
sure the cubic attachment is level
and sits securely under the three
horizontal tabs found inside the
processing bowl close to the top
edge (See Fig. 6).
Fig. 6
5. Align the star shaped end of
the cube cutter shaft with the
matching star shaped hole in
the disc and drop inside the
assembled cubic attachment.
Make sure the shaft drops all the
way down and fits onto the metal
pivot inside the processing bowl
(See Fig. 7).
Operating Your Kambrook Stick Mixer
Continued...