Kambrook KSB400, Instruction Booklet

Page: 14 / 44

13
6. The Stick Mixer will only
operate while either the ‘ON’ or
‘TURBO’ speed control button
is continuously pressed - this is a
safety feature.
To Remove the Masher
Attachment
1. Once mashing is complete,
release the ‘ON’ or ‘TURBO’
speed button, switch the power
off at the power outlet and
unplug the power plug from
the outlet.
2. To remove the masher from the
Stick Mixer motor, press the two
‘Release’ buttons found at the
drive end of the Stick Mixer motor
and pull the masher away from
the motor.
3. To separate the masher
attachment connector from
the masher attachment, turn
the masher attachment in a
clockwise direction and
pull apart.
Recommendations when using
the Stick Mixer with the Masher
Attachment
• The Stick Mixer is powerful
and processes quickly. It is
recommended that in order to
avoid ‘over mashing’ potatoes,
stop the Stick Mixer and
check the consistency of the
foodstuffs regularly.
• The masher attachment allows for
foodstuffs to be mashed directly in
the saucepan. For safety reasons,
always remove the saucepan from
the heat and allow to cool to room
temperature before mashing.
• When mashing, ensure the
potatoes are cut into uniform
sizes and fully cooked to ensure
even and consistent results.
• Ensure the body of the Stick Mixer
and power cord are kept away
from any heat source.
NOTE:
The masher attachment
should only be used for mashing
tasks; do not use it to blend.
Cubic Attachment
To assemble the Cubic Attachment
into the Food Processor Bowl
WARNING: The cube
cutter blade and disc
are extremely sharp and
should only be handled
by the plastic parts.
The cubic attachment is used to dice
fruits and raw or cooked vegetables,
such as carrots, pumpkin and onions.
1. To use the cubic attachment, the
cube cutter blade and blade
disc must first be assembled into
the blade holder. To do this, sit
the blade holder on a bench so
that the protruding cylinder is
facing downwards and pull the
four locking clips away from the
edges of the blade holder. Next,
holding the cube cutter blade by
the outside plastic edges, align
the tab on the cube cutter blade
with the matching groove on the
blade holder and drop into the
blade holder cavity (See Fig. 4).
Make sure the cube cutter blade
sits securely and flush inside the
cavity of the blade holder.