Kaleidescape Part No. 101-0105-00 Rev 4
Page 169
Kaleidescape Premiere Line Installation Guide
Network Requirements
Resetting a Player or Disc Vault to Use a DHCP Address
To remove a static IP configuration on a player or disc vault, press the
network
RESET
button on the back of the component to restore the factory
default DHCP setting. The network
RESET
button is located just left of the
analog audio connectors on Premiere line players including the M700 Disc
Vault, or in the middle of the back panel on the DV700 Disc Vault. Locations
of the
RESET
button can be viewed in the section titled,
Players in the Premiere Line on page 29
Note:
For servers and legacy players, the configuration must be changed on the
browser interface
NETWORK
settings.
To activate the
RESET
button, insert a paperclip in the reset hole. Press until
the indicator on the right side of the
Network
connector starts blinking, then
release. The player or disc vault restarts with the factory default DHCP
setting.
Assigning Static Network Addresses
If the installation site does not have a DHCP server, or if DHCP cannot be
used for Premiere line components, IP addresses can be assigned manually.
See
. Add a DHCP server temporarily to the site
network to access the browser interface and enter IP settings that are valid
for the local site network.
Configuring Network Settings from the Serial Port
All Premiere line components, with the exception of the M300 Player, have a
serial port (RS-232). If the IP address cannot be determined, it can be reset
or changed by connecting a DB-9 serial cable to the serial port of the
Premiere line component and a standard DB-9 serial port on a computer (or
a known good USB to serial adapter). Use a straight-through cable for
players and a crossover cable for servers.
Refer to the Knowledge Base article at
www.kaleidescape.com/go/set-
network-settings
for a list of commands.
