Kaleidescape Part No. 101-0105-00 Rev 5
Page 60
Kaleidescape Premiere Line Installation Guide
Physical Installation
When a Disk Cartridge Can Be Removed
If a server is powered on, the disk cartridge can be removed ONLY under the
following conditions:
• Disk cartridge status light glows amber which indicates that the disk
should be removed.
• Disk cartridge status light is unlit indicating that the disk is not being
recognized at all. (This could be just a seating problem.)
If more than one disk cartridge status indicator glows amber or is unlit on
the same server, turn the server off immediately by pressing the
POWER
button, and contact Kaleidescape Support at +1 650-625-6160 or send a
message to
.
When a Disk Cartridge Does Not Glow Blue
Active disk cartridge status lights glow blue. If a disk cartridge status
indicator light fails to glow blue when the server is powered on, it is usually
for one of the following reasons:
• The disk cartridge is improperly installed.
Power off the server, remove the disk cartridge, and reinsert. Be
sure that the disk cartridge is firmly seated.
• The disk cartridge is defective.
Power off the server and remove the disk cartridge. Contact
Kaleidescape Support for assistance.
• The disk cartridge was previously installed in another server.
Removing and Adding Disk Cartridges
Use the following procedure to remove a disk cartridge or blank from a 3U or
1U+ Movie Server.
1. Access the front panel of the server.
3U Server
– Pull down the front panel.
1U+ Movie Server
– Tug gently on both sides of the front panel and
remove.
Do not operate the server with empty slots. Always use blank
cartridges to fill slots. Open slots compromise the cooling
system.
